When masking, how can I make a curved line and then go back to creating a straight one.
TheRetonator
Website User Posts: 4
When I'm masking out an objects and hold down left click it creates a curved line for the mask. When I try to add the next point, it automatically makes the line curved even if I don't drag. This has made it impossible to mask out most objects, so I usually don't add curves. Is there any way that I can disable this.
Comments
-
Stargazer54 Moderator Moderator, Website User, Ambassador, HitFilm Beta Tester Posts: 3,000 Ambassador
@TheRetonator Clicking and then dragging turns on curves. But you can select any point, right click and change it back to linear. It should stay that way until you click and drag again. Vice versa, right click on a point and you can change it to curve, delete, etc.
Double clicking on a point in the mask will select them all and you change them all from linear to curve and back again.